Simple ceiling lamps are actually more suitable in rental houses. Although they are not as gorgeous and luxurious as crystal lamps, they are simple and generous. The sales volume is much higher than that of crystal lamps due to their convenient installation. However, I believe that everyone still has doubts about the details of the steps for installing simple ceiling lamps. Today, the editor will tell you about the installation method of simple ceiling lamps and the precautions for drilling holes.
Preparation before installing simple ceiling lamps
1. Drilling before installation: Generally speaking, ceiling lamps need to be fixed by drilling holes, so you must first select a suitable electric drill and install the drill bit on the electric drill. The holes on the ceiling are generally 6mm. Installation requires the selection of suitable electric drill specifications.
2. Find the hole position on the top plate of the suction cup: take the hanging plate off the ceiling plate → align it with the ceiling plate → screw it in. If you have not aligned the empty position, pay attention to adjust the position of the screw.
3. Drilling: mark on the wall → drill holes. Be sure to pay attention to the depth of the holes when drilling.
4. Install expansion screws: insert the expansion screws into the holes → hammer them in with a hammer.
5. Fix the hanging board: embed the expansion screws completely into the wall → fix the hanging board, be sure to install it firmly, and do not allow the wood screws to deviate.
6. Install the expansion screws: connect the hanging board and the ceiling plate with screws → tighten the screws and fix the ceiling plate. That's it
Simple ceiling light installation 6 steps
1. Installation tools
To install the ceiling light, we must first prepare the required installation tools such as: impact drill, electrician pliers, screwdriver, insulating tape, a small piece of wood, and a wooden ladder.
2. Choose a good location
The first thing to do when installing a ceiling light is to determine the location of the ceiling light. A linear incandescent lamp or fluorescent lamp should be installed in the front part facing the cabinet. In this way, part of the light emitted by the lamp will be directed to the back baffle, then reflected to the operating table, and then to the center of the entire space.
3. Remove the ceiling lamp mask
Remove the ceiling lamp mask, and then remove the lamp tube. Generally, the ceiling lamp has two fixing methods: rotation and snap-on. Be careful when removing it to prevent the lamp tube from being broken during installation.
4. Install the base
First, we insert the previously reserved wires into the wire hole of the base, use one hand to hold the base of the ceiling lamp and place it in the position to be installed, then use a screwdriver to screw one of the screws into the empty space, and be careful not to screw it too tightly, so that you can check that the position is not accurate before moving it, and then check that the position is correct.
5. Connect the wires
After fixing the base, you can connect the power cord to the ceiling lamp's terminal block. It should be noted that the two wire ends connected to the ceiling lamp power cord should have good electrical contact, and they should be wrapped with black tape respectively and kept at a certain distance.
6. Install the mask pendant
After installing the mask and pendant and connecting the wires, you can try to turn on the power. If everything is normal, you can turn off the power and install the mask of the ceiling lamp.
Precautions for installing simple ceiling lamps
1. Before installing the lamp, you should check whether the power supply at home is turned off, or the reserved wires in the place where it needs to be installed are not powered, otherwise it will endanger life safety. It is recommended to find a professional installation master on the Qibingdaojia platform to help install it.
2. The two wire ends connected to the power supply line of the ceiling lamp should have good electrical contact, and they should be wrapped with black tape respectively, and keep a certain distance. If possible, try not to put the two wire ends under the same piece of metal to avoid short circuit and danger.
Luxsky lighting's ceiling lights are quick and easy to install, click the link to view.
